- All
- Product Name
- Product Keyword
- Product Model
- Product Summary
- Product Description
- Multi Field Search
Views: 249 Author: Site Editor Publish Time: 2022-02-10 Origin: Site
Rodless cylinder saves valuable space for mechanical equipment. At the same efficiency, the total length of rodless cylinder is about half that of traditional cylinder. In addition, if the external guide is installed for the rodless air cylinder, it will become more universal.
The external guide can make the slider bear lateral force and torque, so that tools or other drivers can be directly installed on the guide. The adjustable sliding guide can handle high torque and force in all directions. The following describes how to use special tools and parts to install the external guide on the rodless magnetic cylinder.
Procedure For Installing The External Guide
Place the carriage on the body of the rodless single acting cylinder and place the cut outs of the carriage adjacent to the yoke of the cylinder.
Insert the guide strip into the channel of the carriage and into the V-groove of the cylinder body.
Slide the other guide strip into place. The carriage should be horizontal and slightly higher than the cylinder body.
Apply sealant to the threads of the grub screws on both sides of the carriage for better sealing.
Screw in the two dog point grub screws on either side of the carriage until the screws are tightened.
Insert the two steel strips from the other end of the carriage into the groove of the guide strip until they touch the grub screw at the other end, and then tighten them.
Screw in the remaining grub screws until your hand feels a little resistance when tightening the screws.
Adjust the screw until the carriage can move freely, but it is necessary to ensure that the carriage does not move laterally.
Align the yoke with the carriage, assemble the clamping wedge and tapered nut together, and finally install them on the carriage.
Place the screw in the washer and apply adhesive. Push in the clamping wedge and cone nut, leave a gap between the side carriage and the cylinder yoke, and then tighten the screws.
Characteristics Of Rodless Cylinders
The most obvious feature of rodless hydraulic cylinder is small installation size, which can save more axial space. In addition, the surface of the piston rod of the standard cylinder is easy to accumulate dust and rust, and the sealing ring may also inhale dust, resulting in seal failure. The external slider of the rodless pneumatic cylinder has no moving seal, so there is no need to worry about leakage.
Generally, both ends of the rodless telescopic cylinder are equipped with threads and nuts, so it can be directly installed on the equipment. The rodless cylinder has a small load and is suitable for loading small workpieces. When the rodless double acting cylinder moves back and forth, its sliding block may rotate, so a guide device must be installed.
Rodless air piston cylinder is usually used as an actuator in pneumatic system, which can be used for doors of automobile, subway and CNC machine tools. In addition, the rodless compact cylinder can work normally in high-temperature and low-temperature environment, and has dust-proof and waterproof capacity, which can adapt to various harsh environments.
